Oxy Fuel Cutting Equipment - Welding and Fabrication

Oxy-fuel cutting equipment uses oxygen with acetylene, propane, or another fuel gas to cut carbon steel and other ferrous materials. Marine sets typically include cylinders, regulators, hoses, flashback arrestors, torch handles, cutting attachments, tips, and accessories.

ProShipWorks provides end-to-end support to source and supply Oxy Fuel Cutting Equipment for marine vessels, ship operators, industrial facilities, maintenance teams and procurement departments.

Last updated: October 11, 2026

Product Information

Product Name	Oxy Fuel Cutting Equipment
Product Category	Welding and Fabrication
Product Reference	1252
Brands / Manufacturers	ESAB, GCE, Harris Products Group, Miller Electric, Victor Technologies
Unit of Measure	Set

Key Features

Key Feature
1. Cuts and bevels carbon-steel plates, pipes, and structural sections
2. Compatible with oxygen and acetylene or LPG fuel gases
3. Interchangeable cutting tips for different thickness ranges
4. Portable equipment suitable for shipyards, workshops, and onboard repair
5. Requires regulators, non-return valves, flashback arrestors, and approved hoses

Applications of Oxy Fuel Cutting Equipment

Application
1. Shipbuilding and ship repair steelwork
2. Removal of damaged plates, pipes, brackets, and structural members
3. Onboard hot work, fabrication, maintenance, and emergency repairs

Models & Manufacturers

Model	Manufacturer
X 21 Cutting Torch	GCE
Model 85 Cutting Torch	Harris Products Group
Journeyman Cutting Torch	Victor Technologies

Technical Specifications

Model	Specification	Value	Unit
General oxy-fuel cutting set	Oxygen operating pressure	Typically 2.0-10.0	bar
General oxy-fuel cutting set	Fuel gas	Acetylene, propane, or other approved fuel gas	—
General oxy-fuel cutting set	Cutting method	Oxygen jet with preheating flame	—
General oxy-fuel cutting set	Typical steel cutting thickness	Approximately 3-300	mm

Standards, Certifications & Class Approval

Review the available standards and approval information relevant to the product. Actual certification, material traceability, inspection and classification requirements depend on the product type, intended application and purchasing specification.

Applicable Standards & Certification	Applicable standards include EN ISO 5172 for hand blowpipes, EN 730-1 for gas welding and cutting equipment safety devices, ISO 3821 for rubber hoses, and ISO 2503 for gas welding regulators. Exact requirements depend on equipment configuration and flag-state rules.
Class Approval	Oxy-fuel equipment is generally accepted when manufactured, tested, and used in accordance with applicable flag-state, shipyard, and class hot-work requirements. DNV, ABS, Lloyd's Register, Bureau Veritas, and ClassNK may require approved components or documented inspection for onboard use; approval is configuration-specific.

Installation, Maintenance & Safety Information

Installation Notes	Install correct regulators, hoses, non-return valves, and flashback arrestors for each gas. Leak-test all connections with approved leak-detection fluid. Keep oxygen equipment free from oil and grease, secure cylinders upright, and route hoses away from heat, sharp edges, and passageways.
Maintenance Tips	Inspect hoses, regulators, torch bodies, tips, valves, and flashback arrestors before use. Clean tips with the correct tip cleaners, replace damaged hoses or seals, and verify regulator operation and leak tightness. Store cylinders and equipment dry, capped, and protected from impact.
Safety Notes	Use only in an authorized hot-work area with a permit, gas testing, fire watch, ventilation, and suitable extinguishers. Wear flame-resistant clothing, gloves, eye and face protection, and safety footwear. Keep combustible materials clear, prevent oxygen enrichment, and close cylinder valves after use.